Gate Repair in Lakewood, CO
Gate repair in Lakewood, CO typically runs $180-$650 depending on whether you’re dealing with corroded hinges on a 1950s ranch gate, a sunken post, or a failed automatic opener. Most repairs finish in a single visit, and our crews are usually on-site within two hours for calls from the 90711, 90712, 90713, and 90714 ZIP codes. If your gate is sagging, grinding, or won’t open with the remote, call (833) 754-7503 and a live person will answer, day or night.
Why Lakewood Homes Are Different
Lakewood was built almost entirely between 1950 and 1954 as one of America’s first large-scale planned suburban communities. That means tens of thousands of nearly identical tract-home lots are now aging in lockstep, and the original wrought-iron and chain-link driveway gates from that era are failing across whole neighborhoods at the same time. Add in the marine-layer moisture that reaches these streets from the Pacific, five to seven miles west, and you get steel hardware that corrodes noticeably faster than in drier inland cities. Gate repair in Lakewood isn’t a one-off job market. It’s a city-wide cohort of 70-year-old hardware reaching the end of its service life together.
Gate Repair in Lakewood
Most of the gate repair calls we run in Lakewood trace back to two root causes: original 1950s hardware that has simply worn out, and moisture-driven corrosion that speeds the process along. The standardized 10-foot driveway openings and pipe-diameter posts repeat block after block, which means our crews know exactly what they’re walking up to before they arrive. For a closer look at how we approach every repair, see our Gate Repair page.
Hinge and Post Repair
The original concrete footings under Lakewood’s 1950s gate posts were never built for seventy years of soil movement and gate weight. Posts sink, gates sag, and hinges twist out of alignment. We re-set posts in new concrete footings sized to the actual load, not the 1950s minimum, and replace worn strap hinges with hot-dip galvanized hardware that breaks the corrosion cycle. Hinge replacement typically runs $180-$280, while a full post re-set with new concrete footing falls between $280-$450.
Weld and Rust Repair
Lakewood’s coastal air attacks exposed steel year-round. Hinges, latches, and opener mounting brackets that would last fifteen years inland often need attention within eight to ten here. We cut out corroded sections, fabricate matching replacements, and weld them in with proper galvanizing or powder-coat finishing. Localized weld and rust repair generally runs $220-$380, and we match the original profile so the fix doesn’t announce itself.
How do I know if my 1950s Lakewood gate hinges need repair or full replacement?
If the gate sags more than an inch below level, drags on the driveway, or the hinge pin wobbles visibly in the barrel, replacement is usually the wiser choice. Repair welding on thin, corroded 1950s strap hinges often fails within a season because the parent metal is too degraded. Call (833) 754-7503 for an honest assessment.
Gate Installation in Lakewood
Gate installation in Lakewood typically runs $1,800-$4,500 for a standard residential driveway gate. The postwar ranch homes here were built with consistent fence lines and gate openings, which means we carry the specific hardware those 1950s tract homes require and rarely need a second trip. Whether you’re replacing a gate that’s finally given out or starting fresh, see our Gate Installation page for the full scope.
Swing Gate Installation
Swing gates remain the most common type on Lakewood’s ranch homes, and they’re what we install most often here. The original single or double swing gates were built to clear a 10-foot driveway with posts set in concrete footers that have now settled, cracked, or heaved with decades of soil movement. We remove the old posts, pour new footers to proper depth, and hang replacement gates with hardware rated for coastal exposure. Standard swing gate installation runs $1,800-$2,800.
Driveway Gate Installation
Every driveway gate we install starts with the existing opening and the driveway grade. The postwar lots here were graded with a subtle crown for drainage, and after seventy years of asphalt overlays, that grade has shifted. A gate that cleared the driveway in 1954 may scrape it today. We measure the actual swing arc and specify gate height and bottom clearance accordingly. Larger driveway gates, including double-gate setups, typically run $3,200-$4,500.
What’s the best material for a new gate in Lakewood’s coastal climate?
Aluminum or galvanized steel with a quality powder coat outlasts standard steel or untreated wrought iron in Lakewood’s salt-air environment. Aluminum won’t rust, though it needs heavier section profiles for equivalent strength. Galvanized steel with a proper finish gives the traditional look with far better corrosion resistance than the original 1950s material. Call (833) 754-7503 to talk through options.
Gate Motor & Opener in Lakewood
Gate motor and opener repair in Lakewood typically runs $180-$450, with most calls completed same-day by technicians who carry parts for the city’s signature 1950s-era steel gates. The most common failure we see is a motor straining against corroded hinges or a shifted post until it overheats and burns out its gears. We service nine automation brands, including Viking and Ghost Controls, so the correct fix happens on the first visit. Learn more on our Gate Motor & Opener page.
Motor Repair
Decades of corrosion on hinges and mounting brackets throw gates out of alignment, forcing motors to strain, overheat, and strip their gears. We see this constantly in the 90711, 90712, and 90713 ZIP codes. Our technicians diagnose the root cause so the new motor isn’t fighting the same bent bracket that killed the last one. Motor repair in Lakewood generally runs $220-$380.
Slide Motor Repair and Replacement
Slide motors take abuse in this climate. When corroded hinge pins seize or posts shift, the gate rack binds against the drive gear, stripping teeth or burning out the motor. We check the full travel path rather than just swapping the motor and hoping. Slide motor repair falls between $280-$520, while full replacement with new rack and safety sensors runs $780-$1,400.
Why does my Lakewood gate motor keep reversing before the gate closes?
Your motor is detecting excess resistance and triggering its safety reverse, usually because corroded hinges, a shifted post, or a bent track section is binding the gate. Motor replacement without fixing the binding just burns out the new unit. Call (833) 754-7503 and we’ll find the mechanical cause first.
Gate Access Control in Lakewood
Gate access control installation and repair in Lakewood typically runs $380-$1,200 for most residential jobs. The challenge on this city’s original gates is that corroded mounting brackets and weakened weld points cause vibration and misalignment that damages electronics over time. We re-brace the frame before installing new hardware so the keypad or intercom doesn’t fail again in six months. See our Gate Access Control page for details.
Keypad Entry Systems
Keypad entry is the workhorse of Lakewood’s 1950s neighborhoods, where homeowners want contractors, family, and deliveries to get through without carrying a remote. A typical keypad installation on an existing swing gate runs $380-$650, including weatherproof mounting and code programming. We install DoorKing and LiftMaster keypads with backlit buttons that hold up to the marine-layer moisture that fogs cheaper units.
Phone Entry Systems
Phone entry systems let homeowners screen visitors from anywhere, whether they’re in the workshop or out of state. A Viking phone entry system installed on a standard Lakewood swing gate runs $850-$1,200, including wiring to the home’s phone line or a cellular bridge. These systems are particularly practical on the longer driveways in the city’s southern tracts, where walking to the gate to release it manually is a genuine inconvenience.
Why did my neighbor’s keypad work but mine doesn’t, even though our gates are identical?
Identical gates don’t mean identical condition. Your neighbor’s gate may have slightly less corrosion at the weld points, or their keypad may have been sealed better against moisture. Sometimes a previous homeowner modified the post spacing with aftermarket hardware that doesn’t match the original spec. Call (833) 754-7503 and we’ll diagnose the specific failure.
Gate Parts & Welding in Lakewood
Gate parts and welding repair in Lakewood typically runs $180-$650 depending on the component. The original strap hinges on 1950s wrought-iron and chain-link gates weren’t designed to last seven decades, and the coastal air shortens their life further. Because Lakewood’s standardized lot widths mean predictable hardware, our trucks carry the exact hinge lengths and bolt patterns that fit. For the full range of what we fabricate and replace, visit our Gate Parts & Welding page.
Hinge Replacement
Hinge replacement is the most common call we run in Lakewood. The standardized 10-foot openings mean we carry the correct hinge lengths and bolt patterns without modification. A typical hinge replacement runs $180-$340 for a standard swing gate, including hardware and labor. We use low-maintenance, corrosion-resistant equivalents that won’t need attention again for years.
Custom Welding
When a gate has been modified over the years with welds that were never properly cleaned or painted, the coastal air finds those seams and goes to work. We cut out fatigued sections, fabricate matching replacements, and finish them so the repair doesn’t announce itself. Custom gate welding in Lakewood generally starts around $400 and runs up from there depending on size and ornamental detail.
Why do my gate hinges keep corroding in Lakewood?
The marine-layer moisture and mildly salt-laden coastal air, carried inland from the Pacific about five to seven miles west, corrodes exposed steel faster than in drier inland cities. If your hinges are rusting again within a year or two, they were likely generic replacements without proper coating. Call (833) 754-7503 and we’ll install hardware built for this climate.
Brands We Service in Lakewood
We’re trained and equipped on nine gate-automation brands, including Viking, Ghost Controls, DoorKing, and Elite. We stock common parts locally for those systems, which means most motor and opener repairs happen in a single visit. See our brands for the full list.
Pricing for Gate Repair in Lakewood, CO
| Service | Typical range in Lakewood |
|---|---|
| Hinge replacement (single gate) | $180-$280 |
| Post re-setting with new concrete footing | $280-$450 |
| Weld and rust repair (localized) | $220-$380 |
| Gate realignment (no post work) | $180-$320 |
| Automatic opener repair | $320-$580 |
| Keypad entry installation | $380-$650 |
| Custom welding (fabrication) | $400-$900 |
| Seasonal tune-up | $89 |
What pushes price up in Lakewood is usually the extent of rust damage, whether posts need full replacement rather than re-setting, and whether your opener needs a $40 limit switch or a $400 control board. We diagnose before we quote, and the price is settled before any work starts. No surprises on the bill, ever.
Neighborhoods We Serve in Lakewood
Our Lakewood work concentrates where the original 1950s housing stock remains densest and gate repair demand runs highest. Typical response time across the city is under two hours for non-emergency calls during business hours.
- Lakewood Village
- Belmar area
- Mayfair
- Lakewood Country Club vicinity
Service Area - Cities Near Lakewood
Our crews serve Lakewood and the surrounding communities throughout the west metro. If you’re in Lakewood, CO proper or nearby in Wheat Ridge, CO, Denver, CO, Golden, CO, Arvada, CO, or Columbine, CO, a live person answers at (833) 754-7503, 24 hours a day, 7 days a week.
Serving Lakewood, CO - Our Local Coverage Area
Ironworks Gate Co. crews serve Lakewood and the communities around it; dispatch is coordinated from our Denver office. The map shows the Lakewood coverage area; if your address is on it, we can help.
Also serving nearby: Lakewood, CO, Wheat Ridge, CO, Denver, CO, Golden, CO, Arvada, CO, Columbine, CO.
FAQs About Gate Repair in Lakewood
In most cases, yes. Our crews are usually on-site within two hours for calls placed during business hours across the 90711, 90712, 90713, and 90714 ZIP codes, and most hinge, post, and opener repairs finish in a single visit. Emergency calls are answered by a live person around the clock. Call (833) 754-7503 to check current availability.
For most 1950s gates, repair is the better first move unless the frame is structurally compromised or rust has thinned the steel at the post bases. We give you an honest assessment either way, with a firm price before any work starts, so you can decide with real numbers in hand. Call (833) 754-7503 for a free estimate.
Yes. Many Lakewood neighborhoods have active HOAs with specific rules about gate height, material, and finish. We’re familiar with the common requirements across the city’s tract communities and can match your gate to the neighborhood standard while recovering structural integrity. Call (833) 754-7503 and we’ll walk through what your HOA needs.
If your gate is sagging, stuck, or refusing to open, call (833) 754-7503. We’ll quote a firm price before any work begins, and every job is backed by our written 90-Day Done Right Promise. Done right, and backed in writing.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Lakewood Customers Say
"The loop detector under the driveway had failed and residents were stuck holding the button. He traced it, found the break, and had the exit loop reading cars again the same visit."
- Eric Padgett"Used them at two properties now. Both times they diagnosed it on the first visit instead of guessing and coming back."
- Rohan Shah"The gate works properly now and the price was fair. It did take two visits, because the operator we have is old and the part had to be ordered. They did not charge for the second trip."
- Carrie Mercer