Ghost Controls Keypad & Intercom Repair in Los Angeles, CA

Ghost Controls Keypad & Intercom Repair: The Los Angeles Owner’s Guide

We stock and install Ghost Controls-compatible keypad and intercom repairs across Los Angeles, with most jobs running $280-$520 installed depending on whether we’re replacing a basic keypad or a full intercom station with video. Same-day service is available when you call before noon, and we carry the common Ghost Controls keypad modules on every truck. Most Los Angeles homeowners first realize something’s wrong when the keypad beeps but won’t release the gate, or when visitors press the intercom button and hear nothing back - usually on a morning when you’re already running late.

Call (833) 754-7503

Which Ghost Controls Models This Applies To

Ghost Controls keypads and intercoms fall into a few distinct product families, and matching the right repair means reading the label inside the battery compartment or on the back plate. The AXWK Premium Wireless Keypad, the older AXWV keypad, and the DTP1 Deluxe Wired Keypad each use different mounting patterns and voltage requirements - we’ve seen homeowners in Los Angeles order the wrong replacement online because the housings look nearly identical from the outside. The intercom line is narrower: Ghost Controls offers the DTP2 video intercom and the earlier audio-only models, both of which communicate through the same two-wire low-voltage path to the control board.

We carry OEM Ghost Controls keypads when the model is current, but for discontinued units like the early AXWV series, we source quality aftermarket equivalents that maintain the same 433 MHz wireless frequency and weather sealing. Los Angeles sun is hard on plastic housings, so we prefer aftermarket units with UV-stabilized shells for any keypad mounted without shade. If your gate uses a Ghost Controls TSS1 or TDS2 operator, the keypad pairing process differs slightly - we handle that programming on-site so you don’t need to dig through the manual.

Signs Your Ghost Controls Keypad & Intercom Repair Is Failing

• Keypad lights up but won’t open the gate. This usually means the keypad’s transmitter is working but the pairing with the control board has dropped, or the board’s receiver module is failing. We see this often in Los Angeles after power outages or electrical storms in the San Fernando Valley.
• Intercom button pressed, no sound at the house. The call path runs through low-voltage wiring that can corrode at underground splices, especially in older Hancock Park or Pasadena installations where the conduit has settled. The intercom station itself may be fine while the wire path has failed.
• Erratic beeping or false low-battery warnings on hardwired units. Ghost Controls keypads with voltage regulators can throw phantom battery alerts when the transformer output drifts below 16 VAC. We meter the supply first before replacing a keypad that doesn’t need it.
• Keypad works in morning, fails by afternoon. Heat expansion in the Los Angeles summer can separate cracked solder joints inside the keypad. We’ve traced this to the AXWK in particular when mounted on south-facing gate posts in Glendale and Burbank.
• Video intercom shows snow or drops connection after rain. The DTP2’s camera module relies on a sealed RJ45-style connection that degrades if the grommet wasn’t seated properly at installation. Water intrusion here kills the video circuit while audio may still pass.

Replacement Cost & What’s Included

For Los Angeles homeowners, Ghost Controls keypad and intercom repairs break down as follows:

The spread depends on how much diagnostic time we need, whether new conduit or wire is required, and whether we’re matching an OEM part or fitting a quality aftermarket unit. We settle the full price before starting - no surprises on the bill. Every keypad and intercom repair carries our 90-Day Done Right Promise: if it doesn’t perform as expected, we come back and make it right, no paperwork, no arguing. Senior and veteran homeowners receive our standing 5% discount, and any repair over $250 qualifies for $50 off.

DIY or Call Us?

There’s a short list of checks any homeowner can make safely. Verify the keypad batteries if it’s a wireless unit - use fresh alkalines, not rechargeables, which run at lower voltage. Check your breaker for the gate transformer. Make sure the keypad’s learn button hasn’t been accidentally pressed, which can clear the pairing.

Beyond that, we recommend calling. Ghost Controls keypads and intercoms connect to line-voltage transformers and low-voltage control boards; miswiring can damage the board or create a shock hazard. The DTP2 intercom requires proper wire termination and weather sealing - we’ve been called to Los Angeles homes where a DIY install trapped moisture and destroyed a $400 intercom within months. Our technicians carry the correct crimpers, dielectric grease, and UV-rated grommets on every truck. Most keypad and intercom replacements take under 90 minutes, and we handle the programming so your remotes and keypad codes work the same as before. Call (833) 754-7503 for a free estimate - we’ll give you an honest read on whether it needs replacement or just a careful repair.

FAQs

How long does a Ghost Controls keypad last in Los Angeles?

Four to seven years is typical for a Los Angeles installation, with direct sun exposure being the main variable. Keypads under eaves or shade structures hold up longer; those on unshaded wrought-iron gates in the Valley often show UV damage in three years. Call (833) 754-7503 if yours is acting up - estimates are free.

Can my Ghost Controls intercom be repaired, or does it need full replacement?

Audio intercoms with failed speakers or microphones can sometimes be repaired at the component level, but video units like the DTP2 almost always require replacement once the camera or display circuit fails - parts are not available separately. We diagnose first and tell you straight which path makes sense. Call (833) 754-7503 to schedule a look.

How long does a keypad or intercom swap take?

Most replacements are completed in 45 to 90 minutes, including removal, mounting, wiring, and pairing with your Ghost Controls operator. If we need to pull new wire through existing conduit, add 30 to 60 minutes. We aim to finish in one visit. Call (833) 754-7503 for same-day scheduling.

Do you stock Ghost Controls keypads and intercoms on your trucks?

We carry the AXWK keypad, common aftermarket equivalents, and DTP2-compatible intercom stations on every Los Angeles service vehicle. For discontinued models, we can usually source the correct match within 24 hours. Call (833) 754-7503 and we’ll confirm what’s available for your specific model.

A gate should open when you need it to and stay closed when you don’t. Everything else is just the work. We’ve been handling that work for Los Angeles homeowners since 1984, and Victor still answers calls when his daughter lets him - which isn’t as often as he’d like.

Written by Victor Salinas, Owner, Ironworks Gate Co. at Ironworks Gate Co., serving Los Angeles and nearby areas.